Mitsubishi Melsec-Q QD75D1, Руководство пользователя, Страница: 151 / 858

5 - 47
MELSEC-Q
5 DATA USED FOR POSITIONING CONTROL
Pr.45 OP address
Set the address used as the reference point for positioning control (ABS system).
(When the machine OPR is completed, the stop position address is changed to the
address set in "
Pr.45
OP address". At the same time, the "
Pr.45
OP address"
is stored in "
Md.20
Current feed value" and "
Md.21
Machine feed value".)
Pr.46 OPR speed
Set the speed for OPR.
Note) Set the "OPR speed" to less than "
Pr.8
Speed limit value". If the "speed
limit value" is exceeded, the error "Out of speed limit value range" (error
code: 910) occurs and OPR is not performed.
The "OPR speed" should be equal to or faster than the "
Pr.7
Bias speed
at start" and " Pr.47 Creep speed".
Setting value, setting range
Setting value buffer memory
address
Item
Value set with peripheral device
Value set with sequence
program
Default
value
Axis 1 Axis 2 Axis 3 Axis 4
Pr.47
Creep speed
The setting value range differs depending on the " Pr.1 Unit
setting".
Here, the value within the [Table 1] range is set.
[Table 1] on next page
1
76
77 226
227 376
377 526
527
0 : Do not retry OPR with limit
switch
0
Pr.48
OPR retry
1 : Retry OPR with limit switch 1
0 78 228 378 528