Mitsubishi Electric C70, Руководство по установке

Страница: 208 / 628

C70 Setup Manual
Appendix 1.3 Base Specifications Parameters
191
【
#1142
】
Mn300 M code number
Set the first number of M code that corresponds to the setup Nos. from 300 to 399.
---Setting range---
0 to 99999999
【
#1143
】
Mn400 M code number
Set the first number of M code that corresponds to the setup Nos. from 400 to 499.
---Setting range---
0 to 99999999
【
#1144
】
mdlkof MDI setup lock
Select whether to enable MDI setting in non-MDI mode.
0: Disable MDI setting
1: Enable MDI setting
【
#1145
】
I_abs Manual ABS parameter
Select how to handle the absolute position data during automatic handle interrupt.
0: Absolute position data will be renewed if manual ABS switch is ON. If it is OFF, data won't be
renewed.
1: Follow the "intabs" state when "#1061 intabs" is enabled
【
#1146
】
Sclamp Spindle rotation speed clamp function
Select how to handle the spindle rotation speed clamp function with the G92S command.
0: G92S command is handled as a clamp command only in the G96 state (during constant surface
speed control).
G92S will be handled as normal S command in G97 state (constant surface speed OFF).
1: The S command in the same block as G92 is constantly handled as a clamp command
【
#1147
】
smin_V Minimum spindle rotation speed clamp type
Specify the type of spindle min. rotation speed clamp value.
0: Rotation speed setting
1: Output voltage coefficient setting
Set “#3023 smini” according to this type setting.
【
#1148
】
I_G611 Initial high precision
Set the high accuracy control mode for the modal state when the power is turned ON.
0: G64 (cutting mode) at power ON
1: G61.1 (high-accuracy control mode) at power ON
【
#1149
】
cireft Arc deceleration speed change
Select whether to decelerate at the arc entrance or exit.
0: Not decelerate
1: Decelerate
【
#1150
】
Fldc0
Not used. Set to "0".
【
#1151
】
rstint Reset initial
Select whether to initialize (power ON state) the modals by resetting.
0: Not initialize modal state
1: Initialize modal state