Mitsubishi Electric C70, Руководство по установке

Страница: 192 / 628

C70 Setup Manual
Appendix 1.2 Machining Parameters
175
【
#8209
】
G60 SHIFT (for M system only)
Set the last positioning direction and distance for a G60 (unidirectional positioning) command.
---Setting range---
-99999.999 to 99999.999 (mm)
【
#8210
】
OT INSIDE
Select whether the stored stoke limit function set by #8204 and #8205 prevents the machine from
moving to the inside or outside of the specified range.
0: Inhibits outside area (Select stored stroke limit II.)
1: Inhibits inside area (Select stored stroke limit II B.)
【
#8213(PR)
】
Rotation axis type
Select the rotation type (short-cut enabled/disabled) or linear type (workpiece coordinate linear type/
all coordinate linear type).
This parameter is enabled only when "#1017 rot" is set to "1".
0: Disable short-cut
1: Enable short-cut
2: Workpiece coordinate linear type
(Note 1) When "2" is set, PLC axes will move as same as when "0" is set.
(Note 2) The movement method varies as follows according to the rotary axis type you designate.
<Workpiece coordinate value>
0,1 : Display range 0° to 359.999°
2 : Display range -99999.999° to 99999.999°
<Machine coordinate value/relative position>
0,1,2 : Display range 0° to 359.999°
<ABS command>
0 : The incremental amount from the end point to the current position is divided by 360, and the
axis moves by the remainder amount according to the sign.
1 : Moves with a short-cut to the end point.
2 : In the same manner as the normal linear axis, moves according to the sign by the amount
obtained by subtracting the current position from the end point.
<INC command>
0,1,2 : Moves in the direction of the commanded sign by the commanded incremental amount
starting at the current position.
<Reference position return>
0,1,2 : The movement to the middle point follows the ABS command or the INC command.
Returns with movement within 360 degrees from the middle point to reference position.
【
#8300
】
P0 (for L system only)
Set the reference X-coordinates of the chuck and the tail stock barrier.
Set the center coordinate (radius value) of workpiece by the basic machine coordinate system.
---Setting range---
-99999.999 to 99999.999 (mm)
【
#8301
】
P1 (for L system only)
Set the area of the chuck and tail stock barrier.
Set the coordinate from the center of workpiece (P0) for X-axis. (radius value)
Set the coordinate value by basic machine coordinate system for Z-axis.
---Setting range---
-99999.999 to 99999.999 (mm)
【
#8302
】
P2 (for L system only)
Set the area of the chuck and tail stock barrier.
Set the coordinate from the center of workpiece (P0) for X-axis. (radius value)
Set the coordinate value by basic machine coordinate system for Z-axis.
---Setting range---
-99999.999 to 99999.999 (mm)