MIMAKI Textile Jet Tx3-1600, Руководство по эксплуатации

Страница: 61 / 218

- 2.7 -
7. Set the curved bar at the standby position. Be
sure that curved section is facing the plotter
and set horizontally.
• The usage of the curved bar is “Adjusting
the curved bar angle” (Refer to Page 2.26)
8. Winding the fabric down by the feeding device
and then pull it out approximately 3 meters.
Check the rotational direction depending on whether the printing
side is rolled inward or outward, and release the roll.
9. Pinch only the center of fabric to lead it.
Change the fabric lead position according on the fabric type.
• Pinch the center of fabric to lead it, it can
lead it smoothly.
a. Lead the fabric through between the
antistatic brush and lapel bar.
The curved secrtion
is leveled.
Antistatic brush
Lapel bar
6. Raise the feeding tension bar and then hook it
to the stopper.
• Tension bar weight adjustment is avail-
able.
(Refer to Page 2.25)
Stopper
Feeding tension bar
Standby position