MIMAKI Textile Jet Tx3-1600, Руководство по эксплуатации

Страница: 26 / 218

- 1.6 -
Configuration And Function
Front face
Name Function
1. Station cover L It is opened when maintenance of the back side of carriage.
2. Peeling sensor Monitors the peeling position of the fabric.
3. Belt encoder roller Checks the amount of belt movement.
4. Front cover It is opened when setting fabric or maintenance internal of the station.
5. Peeling roller Peels off the fabric from the belt.
6. Belt Transports the fabric.
7. Peeling sensor amp Control the peeling sensor.
8 ANR unit Check the ink clogging or deflection during printing.
9. Station cover R It is opened when maintenance of the station. (Refer to Page 1.10)
10. Indicator Green: Data receiving, printing, Red: Error (stop printing)
Red is blinking: warning error
11. Operation panel This panel has the operation keys required for operating the printer and
the LCD for displaying set items, etc.
12. Waste ink tank Collects waste ink that has been used for cleaning.
13. Ink station Loads ink cartridges or ink pack for ink supply to each head.
14. Take-up tension bar stopper The tension bar is hooked to this stopper when leading the fabric. *1
15. Take-up tension bar Applies proper tension to the fabric to control operation of the take-up
device.
16. Heater Dries the fabric after printing.
17. Fabric edge guide The fabric peeling operation enables to perform more properly.
18. Take-up device It supports to wind up the roll fabric printed, and have the operation
named FORWARD / OFF / REVERSE.
19. Heater cover Protect the heat from the heater
20. Roll holder Light weight roll holder is inserted in the right and left core of roll fabric
to hold the roll fabric. The roll holder is applicable to diameter of fabric
cores with1.35 to 3 inches.
*1: Depending on the plotter, this may be attached on the outside of the device.
1
2 3
4
5
6 7
8
9
10
11
12 13
14
15
16
18
19
17
20
17