MIMAKI Textile Jet Tx3-1600, Руководство по эксплуатации

Страница: 108 / 218

- 2.54 -
Turning the power off
To turn the power off, check first whether there is data received and there remains data that has not
yet been output. Also be sure that the head rests at the capping station.
When you turn the power OFF during printing, the head may not be stored in the capping station or
the absorption roller can not be lower.
Leaving the head without capping for a prolonged period of time may cause clogged nozzle. And
also leaving the absorption roller without lower for a prolonged period of time, it may cause stick to
the belt and break the roller surface and belt surface.
• When the jog mode is displayed on the LCD (Refer to Page 1.16, 2.40),
change to [LOCAL] mode then, turn the device off.
• If the power is turned off while the plotter is engaged in printing, the head
may fail to be stored in the capping station. If the head is left without
capped for an extended period of time, the nozzle will be clogged with dust.
If the power to the device is turned off without the head capped, re-turn on
the power to the device.
• When turn the device off still receiving the data or non printing data has
remains, the absorption roller has been risen. Make sure to delete the data
before turning off.
Steps
1. Make sure not to receive data or remaining
data in the system.
• When the jog mode is displayed on the
LCD (Refer to Page 1.16,2.40),
change to [LOCAL] mode.
2. Make sure that the indicator green light is off.
• In case the green light is on, perform
Data clear. (Refer to Page 2.49)
3. Turn off the power to the computer, etc. that
are connected to the device.
4. Turn off the power to the device.
5. Turn off the power to the heater.
6. Turn off the power to the blower.