MIMAKI Textile Jet Tx3-1600, Руководство по эксплуатации

Страница: 36 / 218

- 1.16 -
Functions of the JOG keys
Each of the keys varies in function according to the time at which it is used.
Before
the fabric detection
Shifts the fabric away from
you.
Moves the fabric toward
you.
When selecting a
function
Restores the last previous
function.
Moves to the next function.
After
the fabric detection
Shifts the carriage to the
left.
Shifts the carriage to the
right.
Shifts the fabric away from
you.
Moves the fabric toward
you.
When inputting a choice
selected among several
alternatives
Selects the next value.
Selects the last previous
value.
• Attention when moving the fabric backward.
The fabric may be caught by the belt and stained by set-off ink. Slack may
occur at the run-out device and necessary tension may not be obtained
when starting next printing. If you need to perform reverse feed, keep the
above points in mind.
MENU mode
A list of setting items displayed on the LCD is called a menu.
A specific operation specified on the operation panel is displayed on the LCD in one of the follow-
ing three modes.
Each of the three modes is explained below.
< LOCAL > mode
This is the mode in which the preparations for printing operation are made.When the power is
switched on and the detection of a fabric is completed, the device enters the LOCAL mode. In
this mode, it is possible to perform the following operations.
(Refer to Page 1.20)
1. Pushing the appropriate [JOG] keys to detect a fabric and set up an origin.( JOG mode )
2. Pushing the [TEST] key to start test plotting.
3. Pushing the [CLEANING] key to start cleaning the head.
4. Pushing the [DATA CLEAR] key to erase the plotting data the device has received.
5. Pushing the [FUNCTION] key to set plotting conditions.
6. Pushing the [ENTER] key to display the guidance. (Refer to Page P.1.22)
• In the LOCAL mode, the device cannot plot data received from the com-
puter. To put the device into operation, change the mode to the REMOTE
mode by pushing the [REMOTE] key.
< REMOTE > mode
This is the mode in which the device plots an image from data it receives from the computer.
If the device is in the LOCAL mode, push the [REMOTE] key to put the device into the REMOTE
mode.
< FUNCTION > mode
This is the mode in which printing conditions can be set.
To set printing conditions, push the [FUNCTION] key while the device is in the LOCAL mode
and switch to the FUNCTION mode (printing function setting mode).