MIMAKI Textile Jet Tx3-1600, Руководство по эксплуатации

Страница: 203 / 218

- 6.11 -
An error occurs in communication
between I/F board and main
board.
The I/F board is not installed.
HOST I/F Timeout error has
arisen during communication
between the host computer and
interface board.
Initial operation failure of the I/F
board and control board.
Improper operation has been
conducted on the operation
panel.
Settings for functions have been
tried to be changed though there
remains received data that has
not yet been printed.
The Xmotor has been overload.
The Ymotor has been overload.
Overcurrent error on the Xmotor
has been detected.
Overcurrent error on the Ymotor
has been detected.
Incorrect height of the capping
station has been detected.
The wiping device is defective.
The device has failed to detect
the fabric.
Error message Cause Corrective measure
Check the output setting of the
host computer.
Install the I/F board.
Check to be sure that the cable is
securely connected to the host
computer and interface board.
Also, check to ascertain that no
error has arisen on the host
computer side.
Turn off the power to the device
and turn it on after a while. If the
same error message appears
again on the LCD, contact your
local distributor to call for service.
Perform a proper operation.
Print all pieces of received data or
execute the data clear function.
Then, change the settings.
Turn off the power to the device
and turn it on after a while. If the
same error message appears
again on the LCD, contact your
local distributor to call for service.
Both edges of the set cloth are not
positioned properly.
If an error is displayed after setting
it properly, contact your dealer or
MIMAKI sales office.
ERROR 20
I/F BOARD
ERROR 21
I / F NONE
ERROR 23
HOST I / F
ERROR 24
I / F INITIAL
ERROR 30
OPERATION
ERROR 34
DATA REMAIN
ERROR 40
MOTOR X
ERROR 41
MOTOR Y
ERROR 42
X OVER CURRENT
ERROR 43
Y OVER CURRENT
ERROR 45
CAPPING
ERROR 46
WIPING
ERROR 50
MEDIA SENSE
ERROR 51
Y ORIGIN
Turn off the power to the device
and turn it on after a while. If the
same error message appears
again on the LCD, contact your
local distributor to call for service.
Check the connection.
The device has failed to detect
the origin.