MIMAKI Textile Jet Tx3-1600, Руководство по эксплуатации

Страница: 98 / 218

- 2.44 -
After Setting The Fabric
Correcting amount of feed depending on fabric [Media Comp.]
The device prints an image on the fabric while feeding it forward little by little.
When the thickness of the fabric changes, the optimum feed rate changes accordingly. If this occurs,
the device may not plot a clear image (e.g., unwanted stripes may appear on the image). To correct
the fabric feed rate according to the fabric thickness, execute this function and make a printing test.
STEP
1. Make sure that the device is the LOCAL mode.
2. Press [FUNCTION] key.
3. Press [ENTER] key.
4. Select [Media Comp.] and press [ENTER] key.
The print standby screen appears.
5. Press [ENTER] key.
Enter the printing width by pressing the JOG keys [ ] and [ ].
6. Press [ENTER] key.
Test printing for correction of the fabric feed rate starts.
7. When plotting finishes, the screen for selecting
view operation execution appears.
Pressing the [ENTER] key moves the media to a position where it
is easy to see.
Pressing the [END] key does not execute view and moves to the
next step.
8. Enter a correction value from the output pat-
tern by pressing the JOG keys [ ] and [ ].
*If the printed pattern has a gap between lines
→ Ener the minus value.
*If lines of the printed pattern overlap
→
Enter the plus value.
SETUP
Select
: TYPE1
Type1
Media Comp.
<ent>
Type1
Print
: Y= ∗∗∗∗
∗∗ Printing ∗∗
Please Wait
Type1
Adjust
= 0
Optimum pattern
Overlap
Gap between lines
<< LOCAL >>
width : 1620mm
FUNCTION
SETUP
<ENT>
Type1
View
: ent