MIMAKI Textile Jet Tx3-1600, Руководство по эксплуатации

Страница: 152 / 218

- 4.10 -
Increasing (decreasing) the right and left margins of the fabric [Margin]
This function sets a dead space to increase/decrease the right and left margins of the fabric. The
blank portion of the fabric is called dead space. (Refer to Page 2.39)
The function is used to increase the margin for binding.
You can set a dead space for each of the right and left margins of the fabric.
• This plotter sets the width of the printing area by detecting the position of
the fabric retainer. The left and right margins can be changed by changing
the position of the fabric retainer. Printing with the full width is possible by
setting the fabric retainer apart from the edge of the fabric.
STEP
1. Select a type.
(Refer to Page 4.4).Here, select [Type.1].
2. Press [ENTER] key.
3. Press [ ] and [ ] key until the display gives
the indication [Margin].
4. Press [ENTER] key.
5. Set a right margin by pressing the JOG keys
[ ] and [ ].
You can set a dead space in the range -9 mm to 95 mm in incre-
ments of 1 mm.
Here, set [10] mm.
6. Press [ENTER] key.
7. Set the left margin as well as the right margin.
8. Press [ENTER] key.
9. Press [END] key three times, and the menu
returns to the LOCAL mode.
SET UP
Select
: TYPE1
<< LOCAL >>
width : 1620mm
TYPE1
Margin
< ent >
TYPE1
LeftMargin
=10mm
TYPE1
LeftMargin
= 0mm
TYPE1
RightMargin
= 10mm
TYPE1
RightMargin
= 0mm
TYPE1
Margin
< ent >
TYPE1
Media Comp.
< ent >