MIMAKI Textile Jet Tx3-1600, Руководство по эксплуатации

Страница: 167 / 218

- 4.25 -
7. Enter the setting value for the adjoining NG
number by pressing JOG key [ ] and [ ].
In case a nozzle clogging has detected continuously and the
adjoining number exceeds the set value in a row, printing operation
should be stopped or interrupted and starting head cleaning.
*Concrete case
Continued 7 nozzle clogging has detected in the second row. The
printing operation should be continued for the set value is “10”.
• Measures should be changed according to
the settings in the step 9 of the “ANRS
Setup” (Refer to Page P.4.21)
8. Press [ENTER] key.
9. Select the tolerance level for the missing shot
dots by pressing JOG key [ ] and [ ].
The good or bad range of the ink adherent position is set at level 0
to level 2. In case the setting judges the position as NG, this NG is
added to Total NG at procedure 5.
[LEVEL0] ..... The setting judges as good even if large parts of dots
deflected.
[LEVEL1] ..... The setting judges as good with some parts of dots
deflected.
[LEVEL2] .... The setting judges as bad with slight position
missing.
• Measures should be changed according to
the settings in the step 9 of the “ANRS
Setup” (Refer to Page P.4.21)
See an example of a printed result on the right.
This is indicated the ink adherent actual position between the Level
1 and Level 2 against an ideal adherent position.
In case the tolerance level has set LEVEL 2, this nozzle is judged
as bad, and then it is added to Total NG.
TYPE1
MissShot
: Level 0
TYPE1
MissShot
: Level 2
Ideal adherence
position
Actual position
LEVEL0
LEVEL1
LEVEL2
Example for position missing dots
＝
0
＝
7
Contenued
Nozzle
clogging
TYPE1
Adjoining NG
= 10
*In case of setting value is 10
*In case of setting value is Level 2