MIMAKI Textile Jet Tx3-1600, Руководство по эксплуатации

Страница: 85 / 218

- 2.31 -
Using the guiding fabric to start printing from the leading edge of the fabric (Roll,
Leaf)
When making printing with the leading edge of the fabric set in the take-up device, a dead space of
about 2 meter is formed on the fabric. Use the guiding fabric for efficient use of the fabric.
Guiding fabric width should be same as the printing fabric considering the aftertreatment.
By attaching the guiding fabric easily with handheld sewing machine etc, printing fabric can be used
effectively.
• If using the guiding fabric temporarily, until set to the take-up device, it is
not necessary to match the width. In addition it is not necessary to attach
with a handheld sewing machine etc, just use the roughly 100mm width
fabric attach with a paper clip instead.
• When performing printing from the leading edge of the fabric without using
the guiding fabric, observe the following points:
∗ Since the leading edge may not be completely fixed, the fabric may be
jammed. Start printing from the portion which is sufficiently fixed.
∗
If printing is started when the leading edge of the fabric has not reached
the roller, “Peeling error” occurs. In this case, recover the error by
blocking or passing by hand the optical-axis line of the peeling sensor
located at the backside of the peeling roller.