MIMAKI Textile Jet Tx3-1600, Руководство по эксплуатации

Страница: 166 / 218

- 4.24 -
Using the ANR unit [ANRS Ctrl]
This function is setting for bad condition criteria for Nozzle clogging.
STEP
1. Select a type. (Refer to Page 4.4)
Here, select [Type.1].
2. Press [ENTER] key.
3. Press [ ] and [ ] key until the display gives
the indication [ANRS Ctrl].
4. Press [ENTER] key.
5. Enter the setting value for the total NG number
of each color by pressing JOG key [ ] and [ ].
In case a nozzle clogging has detected and the total number exceeds
the set value in a color, printing operation should be stopped or
interrupted and starting head cleaning.
*Concrete case
Totally 8 nozzle clogging has detected. The printing operation is to
be stopped for the set value is “5”.
• Measures should be changed according to
the settings in the step 9 of the “ANRS
Setup” (Refer to Page P.4.21).
[CONT] ....... Continues printing.
[STOP] ........ Stops printing. Make sure to perform head cleaning
after appearing the error message on the LCD. Press
[CLEANING] key to perform Head cleaning. After
cleaning, press on the [REMOTE] key to start
printing again.
[AUTO] ....... Interrupts printing to start Head cleaning automati-
cally, and then start printing again.
6. Press [ENTER] key.
SET UP
Select
: TYPE1
TYPE1
Media Comp.
< ent >
TYPE1
ANRS Ctrl
< ent >
TYPE1
Total NG
= 0
TYPE1
Total NG
= 5
＝
0
＝
8
Nozzle
clogging
TYPE1
Adjoining NG
= 0
*In case of setting value is 5