MD Helicopters 369-500, Инструкция по техническому обслуживанию

Страница: 485 / 722

CSP-HMI-3
MD Helicopters, Inc
.
MAINTENANCE MANUAL
[ Main Menu ]
[ HMI − 3 Book TOC ]
[ Chapter 96 TOC ]
96-10-00
Page 213
TR16-001
The information disclosed herein is proprietary to MD Helicopters, Inc.
Neither this document nor any part hereof may be reproduced or transferred to
other documents or used or disclosed to others for manufacturing or any other
purpose except as specifically authorized in writing by MD Helicopters, Inc.
Copyright
©
1999 − 2016 by MD Helicopters, Inc.
G96-1004
SLOT IN BRUSHES
(MAXIMUM WEAR
POINT)
SPRING
END BELL VIEW
SATISFACTORILY SEATED BRUSHES
UNSATISFACTORILY SEATED BRUSHES
100%
100% 100%
100%
90%
90%
NONSEATED AREAS
SEATED AREAS
NOTE:
HELICOPTER AMMETER INDICATOR
CIRCUIT TERMINAL.
Figure 205. Starter/Generator − Brush Seating and Wear Limits
12. Starter/Generator Repair
(Ref. Figure 204) For starter/generator repairs,
maintenance of starter brushes is the only
repair information provided. For all other
starter/generator repairs, refer to manufactur­
er's instructions (Ref. Sec. 01-00-00).
Consumable Materials
(Ref. Section 91 − 00 − 00)
Item Nomenclature
CM801 Abrasive paper, silicon carbide
(1). Removing Brushes:
(a). Remove the four screws that secure
the fan cover and brush access cover
to the generator end bell; remove fan
cover.
(b). Remove the screw from the lead
terminal of each brush set and lift
out the brush sets.
(2). Checking Brush Spring Tension:
(a). Remove brushes from starter/genera­
tor.
(b). Cut a groove down the center of both
edges and across the bottom of a new
brush. When prepared in this man­
ner, the brush will have a continuous
groove around three sides.
(c). Place a fine wire around the brush in
the groove; then insert the brush in
one of the brush holders. Tie the two
ends of the wire together to form a
loop and attach a fish-type spring
scale that is graduated in ounces.
(d). Raise the brush by the scale until the
lower end of the brush is even with
the bottom edge of the brush holder.
When in this position, the brush
spring tension should be between 32
and 48 ounces (907 and 1361 grams).
(e). Take an average of several readings.
If the spring tension is out of this
range, replace the spring.
(f). Measure the brush spring tension in
the remaining brush holders.
(3). Replacing Brushes and Preliminary
Seating (Ref. Figure 205).