MD Helicopters 369-500, Инструкция по техническому обслуживанию

Страница: 186 / 722

CSP-HMI-3
MD Helicopters, Inc
.
MAINTENANCE MANUAL
[ Main Menu ]
[ HMI − 3 Book TOC ]
[ Chapter 95 TOC ]
Page 102
Revision 13
95-30-00
The information disclosed herein is proprietary to MD Helicopters, Inc.
Neither this document nor any part hereof may be reproduced or transferred to
other documents or used or disclosed to others for manufacturing or any other
purpose except as specifically authorized in writing by MD Helicopters, Inc.
Copyright
©
1999 − 2016 by MD Helicopters, Inc.
4. Engine Oil Pressure and Torque Indicating System Troubleshooting
Table 103. Engine Oil Pressure and Torque Indicating System
Symptom Probable Trouble Corrective Action
Pointer fails to respond Pressure line kinked or bent Check entire length of line; replace if
necessary.
Pointer indications sluggish
Obstruction in line Clear line.
Defective gauge Replace gauge.
Pointer indicates incorrectly
Line or line connectors leaking Check for damaged ring gasket
under fitting hex and tighten
connections; if leak persists, replace
line.
Air trapped in line Check for air bubbles and bleed if
necessary.
5. N
1
Tachometer Indicator Troubleshooting
Table 104. N1 Tachometer Indicator Troubleshooting
Symptom Probable Trouble Corrective Action
Rpm indicator fails to operate. No
readings or intermittent readings
Defective indicator Remove and replace indicator.
Defective tach generator Remove and replace tach generator.
Loose wiring, disconnected
connector or defective ground
terminal
Check continuity through wiring and
connector. Repair as necessary.
6. N
2
/N
R
(N
R
/N
P
) Tachometer Indicator Troubleshooting
Table 105. N
2
/N
R
(N
R
/N
P
) Tachometer Indicator Troubleshooting
Symptom Probable Trouble Corrective Action
Rpm indicator fails to operate. No
readings or intermittent readings
Defective indicator Remove and replace indicator.
Defective tach generator Remove and replace tach generator.
Loose wiring, disconnected
connector or defective ground
terminal
Check continuity through wiring and
connector. Repair as necessary.