MD Helicopters 369-500, Инструкция по техническому обслуживанию

Страница: 446 / 722

CSP-HMI-3
MD Helicopters, Inc
.
MAINTENANCE MANUAL
[ Main Menu ]
[ HMI − 3 Book TOC ]
[ Chapter 96 TOC ]
Page 202
Revision 8
96-05-00
The information disclosed herein is proprietary to MD Helicopters, Inc.
Neither this document nor any part hereof may be reproduced or transferred to
other documents or used or disclosed to others for manufacturing or any other
purpose except as specifically authorized in writing by MD Helicopters, Inc.
Copyright
©
1999 − 2016 by MD Helicopters, Inc.
G96-0006A
HI-LIMIT
SWITCH
FIBERGLASS
SLEEVING
CELL HOLD-
DOWN BAR
COVER NOTE 1
FILLER CAP
VENT PLUG
TERMINAL SCREW
(NOTE 2)
LOW-LIMIT
SWITCH
TERMINAL WASHER
BAFFLE
BUS BAR
HIGH TEMPERATURE
SWITCH RED PAINT
MARK
TERMINAL
FILLER
VENT
TEMPERATURE
SWITCHES-INSTALLATIO
N (TYP)
CELL
(NOTE 3)
VENTILATION GAP
(BOTH SIDES)
NOTE 4
NYLON SEPARATOR
CASE
GUSSET
(OPTIONAL)
TYPICAL BUS CONNECTION
TO RECEPTACLE
NOTE 6
RECEPTACLE BUS STRIP
(NOTE 5)
CONNECTOR SEPARATOR
(VINYL PLASTIC-COVERED
CORROSION RESISTANT
STEEL SHEET)
J108 RECEPTACLE
(NOTE 5)
NOTES:
1. SCREW, WASHER AND NUT USED FOR SHIPMENT, HANDLING
AND STORAGE.
2. SCREW TORQUE: 15 - 18 INCH-POUNDS (1.69 - 2.03 NM).
3. CAUTION: COMPLETE SET OF SAME MANUFACTURER'S CELLS
MUST BE USED. MIXING OF DIFFERENT MANUFACTURER'S
CELLS IS NOT ALLOWABLE. (REFER TO MANUFACTURER'S
INSTRUCTIONS, SEC. 01-00-00).
4. CELLS ARE SHOWN NUMBERED FOR REFERENCE ONLY.
5. CONNECTOR BUS STRIPS AND BACK OF CONNECTOR COVERED
TO WITHIN 0.62 INCH (15.748 MM) OF CELL TERMINALS WITH
0.060 INCH (1.524 MM) THICK COATING OF SEALANT.
6. COVERED WITH SEALANT.
Figure 201. Battery and Components Replacement