LSI LSI53C1000, Техническое руководство

Страница: 111 / 384

LSI53C1000 PCI to Ultra160 SCSI Controller 4-1
Chapter 4
Registers
This section contains descriptions of all LSI53C1000 registers. The term
“set” refers to bits programmed to a binary one. Similarly, the term
“cleared” refers to bits programmed to a binary zero. Do not access
reserved bits. Reserved bit functions may change at any time. Unless
otherwise indicated, all bits in the registers are active high; the feature is
enabled by setting the bit. The bottom row of every register diagram
presents the default register values, which are enabled after the chip is
powered on or reset.
This chapter contains the following sections:
•
Section 4.1, “PCI Configuration Registers”
•
Section 4.2, “SCSI Registers”
•
Section 4.3, “SCSI Shadow Registers”
4.1 PCI Configuration Registers
To access the PCI Configuration registers, perform a configuration read
or write to a device with its IDSEL pin asserted. The appropriate address
value is in AD[10:8] during the address phase of the transaction. The
SCSI function is identified by a binary value of 0b000.
Table 4.1 shows
the PCI configuration registers implemented in the LSI53C1000.
All PCI-compliant devices, such as the LSI53C1000, support Vendor ID ,
Device ID , Command , and Status registers. Support of other
PCI-compliant registers is optional. In the LSI53C1000, registers that are
not supported are not writable and return all zeros when read. Only those
registers and bits that are currently supported by the LSI53C1000 are
described in this chapter. Do not access bits marked as Reserved.