LSI LSI53C1000, Техническое руководство

Страница: 91 / 384

Power Management 2-63
Although the PCI Bus Power Management Interface Specification does
not allow power state transitions D2 to D1, D3 to D2, or D3 to D1, the
LSI53C1000 hardware places no restriction on transitions between
power states. The PCI Function Power States D0, D1, D2, and D3 are
described below.
As the device transitions from one power level to a lower one, the
attributes that occur from the higher power state level are carried over
into the lower power state level. For example, D1 disables the SCSI CLK.
Therefore, D2 includes this attribute as well as the attributes defined in
the Power State D2 section. The PCI Function Power States - D0, D1,
D2, and D3 are described below.
2.5.1 Power State D0
Power state D0 is the maximum power state and is the power-up default
state. The LSI53C1000 is fully functional in this state.
2.5.2 Power State D1
Power state D1 is a lower power state than D0. In this state the
LSI53C1000 core is in the snooze mode and the SCSI clock is disabled.
In the snooze mode, a SCSI reset does not generate an INT/ signal.
Table 2.9 Power States
Configuration Register (0x44),
Bits [1:0] Power State Function
00 D0 Maximum Power
01 D1 Disables SCSI clock
10 D2 Coma Mode
11 D3 Minimum Power