Starting up the device - Configuration
Leuze electronic GmbH + Co. KG
BCL 248i
44
Assignment of MAC address – IP address – individual device name
Ä
Assign an IP address (suggested by the PLC), a subnet mask and, if required, a router address, and
assign this data to the named participant ("device name").
ð
From now on, and when programming, only the unique "device name" is used.
Fig. 8.3:
MAC address – IP address – individual device name
8.3.6
Step 6 – Check device name
Ä
After completing the configuration phase, recheck the "device names" that have been assigned. Ensure
that these are unique and that all participants are located in the same subnet.
8.3.7
Manually setting the IP address
If you would like to directly access webConfig, the IP address must be set manually.
On delivery, the device has the following network address:
• IP address: 192.168.60.101
• Subnet mask: 255.255.255.0
Setting the IP address via PC/laptop
Setting the network address on the PC (example for Windows 7):
Ä
Log in as administrator.
Ä
Select
Start > System control > Network and Internet > Network and Sharing Center
.
Ä
Select
LAN connection
and double-click to open the
Properties
dialog.
Ä
Select
Internet Protocol Version 4 (TCP/IPv4)
and click on the [Properties] button.
Ä
Set the IP address of the PC.
The IP address of the PC must not be identical to the IP address of the sensor.
Example:
• IP address of the sensor: 192.168.60.101
• IP address of the PC: 192.168.60.110
Ä
Set the subnet mask of the PC to the same value as on the sensor.
