Lenovo ThinkServer TD350, Руководство пользователя и руководство по техническому обслуживанию аппаратного обеспечения

Страница: 141 / 226

9. Connect the power cable 1 and the signal cable 2 to the rear of the flex module.
Figure 86. Connecting cables to the rear of the flex module
10. Do one of the following:
• If you are installing a slim optical drive, save the removed protective shield in case you later remove
the drive and need the protective shield to cover the drive bay.
• If you are replacing a slim optical drive and are instructed to return the old slim optical drive, follow all
packaging instructions and use any packaging materials that are supplied to you for shipping.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to “Completing the parts replacement” on page 180.
Installing or replacing a hot-swap internal storage drive
Attention: Do not open your server or attempt any repair before reading and understanding “Read this first: safety
information” on page iii and “Guidelines” on page 69.
This topic applies only to server models that have hot-swap storage drives installed, such as hard disk
drives or solid-state drives. See “Features” on page 7 for more information about the supported hot-swap
storage drives.
For a list of ThinkServer storage drive options, go to:
http://lenovoquickpick.com/usa/home/thinkserver/rack-and-tower-server
You can install or replace a hot-swap storage drive without turning off the server, which helps you avoid
significant interruption to the operation of the system.
The EMI integrity and cooling of the server are protected by having all storage-drive bays covered or
occupied. The number of the installed storage drives in your server varies depending on the server model.
The vacant bays are either covered by metal protective shields or occupied by dummy storage-drive trays.
Chapter 6
.
Replacing hardware
127