Lenovo ThinkServer TD350, Руководство пользователя и руководство по техническому обслуживанию аппаратного обеспечения

Страница: 105 / 226

To install a PCIe card, do the following:
1. Remove all external media from the drives and turn off all attached devices and the server. Then,
disconnect all power cords from electrical outlets and disconnect all cables that are connected to
the server.
2. If the server is installed in a rack cabinet, remove the server from the rack cabinet and place it on a flat,
clean, and static-protective surface. See the Rack Installation Instructions that comes with the server. If
the server is in tower form factor, lay the server on its side for easier operation.
3. Remove the server cover. See “Removing the server cover” on page 72.
4. Remove the cooling shroud. See “Removing the cooling shroud” on page 75.
5. Locate an appropriate PCIe card slot on the system board for installing the PCIe card. For information
about the PCIe card slots, see “System board components” on page 47.
Note: If you are installing the Lenovo ThinkServer 8885e PCIe 12Gb SAS Adapter by PMC, ensure that
you observe the following guidelines:
• Your server has two microprocessors installed.
• The Lenovo ThinkServer 8885e PCIe 12Gb SAS Adapter by PMC must be installed into the PCIe
card slot 4.
6. Remove any parts and disconnect any cables that might impede your operation.
7. Pivot the latch for the PCIe card slot to the open position.
Figure 51. Pivoting the latch for the PCIe card slot to the open position
Chapter 6
.
Replacing hardware
91