Kurzweil PC3LE, Руководство музыканта

Страница: 89 / 379

Program Mode
The Program Editor
6-37
Pan
Use this parameter to position the current layer’s pre ‐ FX signal. Negative values pan the signal
to the left channel, positive values pan to the right, and a value of zero pans to the center. To
adjust the post ‐ FX , final ‐ stage gain and panning of the current program, go to the COMMON
page and adjust the Output parameters (see The COMMON Page on page 6 ‐ 39).
An additional pan parameter (Pan2) appears if you have the Stereo parameter on the KEYMAP
page set to a value of On .
Pan Mode
When the mode is Fixed the pan position remains as defined with the Pan parameter, ignoring
MIDI pan messages. When the mode is +MIDI , MIDI pan messages (MIDI 10) will shift the
sound to the left or right of the Pan parameter setting. Message values below 64 shift it left,
while those above 64 shift it right. A setting of Auto assigns the pan setting of each note based
on its MIDI note number. In this case, Middle C (MIDI note number 60) is equivalent to the Pan
parameter’s setting. Lower notes shift increasingly left, while higher notes shift increasingly
right. A setting of Reverse shifts low notes right, and high notes left. MIDI pan messages will
also affect the pan position when values of Auto and Reverse are selected.
Output: Pan, Gain, and Mode
Some factory ROM drum programs have layer specific effects. For these programs three
additional parameters appear on the OUTPUT page: Out Pan, Out Gain, and Out Pan Mode.
These parameters are analogous to the output parameters on the COMMON page, but are layer ‐
specific—the COMMON output parameters apply to all layers. You can use the output
parameters on the OUTPUT page to adjust the panning and gain of the post ‐ FX signal of the
current layer .