Kurzweil PC3LE, Руководство музыканта

Страница: 102 / 379

6-50
Program Mode
The Program Editor
Note: Since 0 multiplied by any number equals 0, the envelope parameters on this page will have no effect
on any AMPENV sections set to 0 seconds. A way around this is to change any AMPENV sections set to
0 to 0.02 seconds.
Adjust
This is the familiar Coarse adjust found on many other pages. Use it here to change the rate of
one of the envelope sections without reprogramming the envelope itself. This parameter doesn’t
give you realtime control over the envelope. It is, however, a good way to adjust the natural
envelopes without switching to a User envelope and trying to approximate the Natural
envelope.
Key Tracking
This uses the MIDI note number of each key as the control input for the current layer’s
corresponding envelope section. When the value of this parameter is greater than 1.000x , notes
above C 4 will make the envelope section run faster, while notes below C 4 will make it run
slower. When the value of this parameter is less than 1.000x , notes above C 4 will make the
envelope section run slower, and notes below C 4 will make it run faster. This gives you realtime
envelope control right from your MIDI controller. You might use it, for example, to cause an
acoustic guitar sound to decay quicker at the high end of the keyboard (set the key tracking to a
positive value).
Velocity Tracking
Use your attack velocity as the control input for the current layer’s attack section (this parameter
doesn’t apply to decay or release). When the value of this parameter is greater than 1.000x ,
attack velocities greater than 64 make the attack section run faster, and attack velocities below 64
make it run slower. This gives you realtime attack control over the envelope.
Source, Depth
These two parameters work together to let you assign a control like the Mod Wheel to affect the
current layer’s amplitude envelope in realtime. The value of the Source parameter defines which
control affects the envelope section, and the value of the Depth parameter defines how much the
rate is multiplied when the control is at its maximum value, 127. No effect is had when the
control is at its minimum value, 0, and Depth values are scaled for controller values in between.
Note: For each note triggered, you can only set the controller value that will scale the Depth parameter of
an envelope section before that section of the envelope is triggered. For controllers assigned for Attack, the
controller value used will be the last received before the note is triggered. For controllers assigned for
Decay, the controller value used will be the last received before the final section of the attack envelope
reaches its maximum amplitude. For controllers assigned for Release, the controller value used will be the
last received before the note is released. To put it another way, for each envelope section, you cannot
change the rate of a note’s envelope once that section of the envelope has been triggered.
Parameter Group (Available
for each of Att, Dec, Rel, Imp)
Range of Values
Adjust 0.018 to 50.000x (-24.0 to 24.0 dB for Imp)
Key Tracking 0.018 to 50.000x (-2.00 to 2.00 dB for Imp)
Velocity Tracking 0.018 to 50.000x (Not available for Dec or Rel; -24.0 to 24.0 dB for Imp)
Source Control Source List
Depth 0.018 to 50.000x (-24.0 to 24.0 dB for Imp)