Kongsberg Simrad TV80, Справочное руководство

Страница: 83 / 356

406388/F
81
Setting up summary
Before a new TV80 system can provide any information you must set it up. You
must first install the software. In order to add one or more catch monitoring sensors
to your system, you must first connect the necessary receiver unit(s), and define the
communication parameters. Finally, you must set up the communication parameters for
your navigation sensors.
Prerequisites
• All system units have been installed.
• All cable connections have been made and checked.
• All system units have been inspected.
• The operational software is available.
• The software license is available.
Procedure
1 Do the following preparations.
a Turn on the computer.
b Make sure that you have administrative rights.
c Switch off any firewall applications.
d Open the operating systems’s Network and Sharing Center , and set the IP
address for the network adapter used to communicate with the transceiver.
•
IP Address
: 192.168.1.30
•
Subnet mask
: 255.255.255.0
2 Install the software.
Installing the TV80 operating software, page 59
3 Install the software license.
Obtaining and installing the software license, page 60
4 Connect the Receiver Unit(s) to the computer.
5 Set up the relevant Receiver Unit(s).
Setting up the interfaces to peripheral devices, page 116
6 Select the gear you wish to use.
Selecting gear, page 68
7 Select one or more catch monitoring sensors, and place them on the chosen gear.
Adding new catch monitoring sensors, page 68
Configuring catch monitoring sensors’ parameters and defining their measurements,
page 137
Operating procedures