Kongsberg Simrad TV80, Справочное руководство

Страница: 145 / 356

406388/F
143
Configuring a PX TrawlEye sensor
You can program the TrawlEye to suit your operational needs or read the configuration
it has with its relevant configuation dialog box. When you configure a PX TrawlEye
sensor, you can select key parameters related to its echo sounder, check its battery
status or even configure some special features like the learn mode. The configuration
parameters available in the relevant configuration dialog boxes allow you to set up which
measurements the sensor shall make and which communication channels it shall use
for these measurements.
Prerequisites
This procedure assumes that a suitable receiver unit has been connected to the Processor
Unit, and that all relevant communication parameters have been defined.
This procedure assumes that a sensor is connected to the computer with the configuration
cable.
Context
Catch monitoring sensors are delivered from Kongsberg Maritime readily set up with
common default settings. In some cases, you may find that the default parameters do
not suit your operational needs. Each individual sensor can be configured to specify
its communication channel, which measurements to make and some other relevant
operating parameters.
Note
If your new sensor has already been configured, you do not need to repeat the
configuration process to use it.
Procedure
1 Open the
Setup
menu.
2 On the
Setup
menu, select
Installation
.
Observe that the
Installation
dialog box opens.
3 Observe the
Select Gear
page at the left of the
Installation
dialog box
Select a gear icon according to your working environment.
4 At the bottom of the
Sensor list
page, select
Add New Sensor
.
The
Add New Sensor
dialog box opens.
5 Select
Yes
.
6 In the very first
PX Sensor Configurator
dialog box, select communication port
and sensor type, then select
Connect
.
The
PX TrawlEye Configurator
dialog box opens.
Operating procedures