Kongsberg Simrad TV80, Справочное руководство

Страница: 142 / 356

140
406388/F
3 Observe the
Select Gear
page at the left of the
Installation
dialog box
Select a gear icon according to your working environment.
4 At the bottom of the
Sensor list
page, select
Add New Sensor
.
The
Add New Sensor
dialog box opens.
5 Select
Yes
.
6 In the very first
PX Sensor Configurator
dialog box, select communication port
and sensor type, then select
Connect
.
7 In
Select Receiver
, at the top of the dialog box, select PI type receiver.
8 In the gear illustration, select the location of the sensor.
9 Select the direction the sensor is going to point to, either to the vessel or to the trawl.
10 Choose the measurements you want the sensor to make and define the relevant
parameters.
When interfacing a PI type receiver unit, the maximum number of measurements a
sensor can make is two. Remote functions are not considered as a measurement.
11 Select the communication
Channel
.
This is specially important if you wish to use several sensors to operate on
different communication channels. This is also important to avoid interference if
several vessels equipped with identical catch monitoring systems are operating
simultaneously in the same area.
12 Select
Calibrate Sensor
.
If you want your sensor to measure the pitch and roll of the trawl doors, you must
calibrate it.
13 Select
Program Sensor
to transfer the chosen parameters to the sensor.
14 In the
Sensor list
page, verify if the sensor appears with the correct parameters.
15 Disconnect the sensor from the interface cable and the computer.
Result
The sensor is configured for use.
Related topics
Introduction to PX Sensors Configuration dialog boxes, page 259
Simrad TV80 Reference Manual