Juniper JUNOSE 11.1.X MULTICAST ROUTING, Руководство по настройке

Страница: 169 / 270

Chapter 5
Configuring IPv6 Multicast
IPv6 multicast enables a device to send packets to a group of hosts rather than to a
list of individual hosts. This chapter describes how to configure IPv6 multicast on
the E Series router; it contains the following sections:
■
IPv6 Multicast Overview on page 147
■
Platform Considerations on page 149
■
References on page 150
■
Before You Begin on page 150
■
Configuring the Switching Fabric Bandwidth on page 150
■
Enabling IPv6 Multicast on page 150
■
Defining Static Routes for Reverse-Path Forwarding on page 151
■
Displaying Available Routes for Reverse-Path Forwarding on page 151
■
Enabling and Disabling RPF Checks on page 152
■
Using Unicast Routes for RPF on page 153
■
Defining Permanent IPv6 Multicast Forwarding Entries on page 153
■
Defining a Multicast Bandwidth Map on page 154
■
Configuring Multicast QoS Adjustment on page 158
■
Activating Multicast QoS Adjustment Functions on page 160
■
Configuring Hardware Multicast Packet Replication on page 160
■
Blocking and Limiting Multicast Traffic on page 168
■
Deleting Multicast Forwarding Entries on page 172
■
Monitoring IPv6 Multicast Settings on page 172
■
BGP Multicast on page 181
IPv6 Multicast Overview
IPv6 defines three types of addresses: unicast , anycast , and multicast . Each type of
address enables a device to send datagrams to selected recipients:
■
A unicast address enables a device to send a datagram to a single recipient.
■
An anycast address enables a device to send a datagram to one recipient out of
a set of recipients.
IPv6 Multicast Overview
■ 147