Juniper JUNOSE 11.1.X MULTICAST ROUTING, Руководство по настройке

Страница: 173 / 270

Defining Static Routes for Reverse-Path Forwarding
Use the ipv6 rpf-route command to define reverse-path forwarding (RPF) to verify
that a router receives a multicast packet on the correct incoming interface.
ipv6 rpf-route
■
Use to customize static routes that the router may use for RPF.
■
Specify the IPv6 address and subnet mask of the destination network.
■
Specify either a next-hop IPv6 address or an interface type and specifier, such
as atm 3/0. For details about interface types and specifiers, see Interface Types
and Specifiers in
JUNOSe Command Reference Guide .
■
Optionally, specify the distance (number of hops) to the next-hop address.
■
Example
host1(config)# ipv6 rpf-route 1000::/64 ATM2/1.200
■
Use the no version to remove the static route.
■
See ipv6 rpf-route.
Displaying Available Routes for Reverse-Path Forwarding
Use the show ipv6 rpf-route command to display all available routes, only the routes
to a particular destination, or routes associated with a specific unicast protocol that
the router can use for Reverse-Path Forwarding (RPF).
show ipv6 rpf-route
■
Use to display routes that the router can use for RPF.
■
Specify the IPv6 address and the network mask to view routes to a particular
destination.
■
Specify the detail keyword to view more detailed information about routes to a
particular destination.
■
Specify a unicast routing protocol to view routes associated with that protocol.
■
Field descriptions
■
Protocol/Route type codes—Protocol and route type codes for the table that
follows
■
Prefix—Value of the logical AND of the IPv6 address of the destination
network and the subnet address
■
Length—Length of the subnet mask in bits
■
Type
■
Connect—Subnet directly connected to the interface
■
Static—Static route
Defining Static Routes for Reverse-Path Forwarding
■ 151
Chapter 5: Configuring IPv6 Multicast