Juniper JUNOSE 11.1.X MULTICAST ROUTING, Руководство по настройке

Страница: 254 / 270

undebug ipv6 pim
■
Use to turn off the display of information previously enabled with the debug
ipv6 pim command.
■
Example
host1# undebug ipv6 pim events
■
There is no no version.
■
See undebug ipv6 pim.
Monitoring PIM Settings
You can use the show ipv6 pim commands to display information about PIM settings.
show ipv6 pim
■
Use to view general PIM router-level information.
■
Field descriptions
■
Default PIM Version—Default PIM version number (always 2)
■
Default Domain Id—Default Domain Id (always 0)
■
Default Hello period—Default interval (in minutes) at which the router sends
hello messages to neighbors
■
Default Hello Hold Time—Default time (in minutes) for which the router
keeps the neighbor state alive
■
Join-Prune Interval—Interval value (in seconds) set in the join/prune message
originated by the PIM router
■
Join-Prune Holdtime— Hold time value (in seconds) set in the join/prune
message originated by the PIM router. The hold time is 3.5 times the PIM
join/prune message interval value.
■
Keepalive Period—Time SG join state is maintained in the absence of SG
Join message
■
Assert Time—Period after last assert before assert state is timed out
■
Register Suppression Time—Period during which a designated router stops
sending registers to the RP
■
Register Probe Time—Time before register suppression time (RST) expires
when a designated router might send a NULL-Register to the RP
■
Register TTL—TTL value (in PIM register packets) originated by this PIM
router
■
SSM—State of SSM on this PIM router (enabled or disabled)
■
range—Default SSM group range or name of the access list specifying the
range
232 ■
Monitoring PIM
JUNOSe 11.1.x Multicast Routing Configuration Guide