John Bean B 2000P, Руководство оператора

Страница: 168 / 252

168
7-03
B
7-05
7-06
Operation
CAUTION
: MOVE AWAY FROM THE WHEEL
•
Press on the value (
B, Fig. 7-03
), to automatically
bring the wheel to the right-hand WAP position, apply
the adhesive weight on the end of the gauge arm
and fi x it in the suggested position (“
1
” + “beep”).
—
At the end perform a Test Run.
7.0.1.1 Using the Laser Pointer
In Alu 2P and Alu 3P modes, with the Laser Pointer
mode active, the correction planes for adhesive
weights are precisely indicated by the laser pointer
directly on the rim (
Fig. 7-05
).
Note
: When the indication is given by the laser (if
enabled from service), the weight must not be
fi tted at 12 o’clock, but at the bottom of the
rim, precisely where indicated by the pointer.
Weights application at about 5 o’clock, on the right of
the laser point (
Fig. 7-06
).
There are at least two positions where the adhesive
weights can be fi tted, indicated by the Laser pointer,
depending on the wheel type and the balancing mode.
When a run is completed correctly the BALANCING
screen shows the correction values and the position
where the weights must be fi tted.
To make the corrections,
•
Select an adhesive weight of the indicated size and
adjust it to the wheel radius by bending.
•
If necessary, index the wheel precisely into the
correction position for the left plane. When the
correction position is reached, the two arrows on
the screen light up green.
•
Press the pedal of the main shaft lock to hold the
wheel in this position.
•
Clean the fitting position before attaching the
adhesive weights.
•
Fit the balancing weight and firmly press the
adhesive weight onto the rim.
•
Fit the second adhesive weight in the same manner.
The position for fi tting the weights indicated by the
Laser pointer can be varied for each correction
plane.
•
See “RELOCATION” (
F
6.3.3).
..
_
..........