1
DO NOT START THE MACHINE BEFORE READING CAREFULLY THESE
INSTRUCTIONS
REMARK :
Wheel balancing machine TROLL 3100 isn”t equiped an automatic ultrasonic system measurement
geometrical parameters of balanced wheel. All description concern the service this system, placed
in present manual instruction, arent conforming to this type machine.
The balancing machine TROLL 3105 is provided
with an automatic measurement system geometric
for measuring parameters of the wheel balanced, start while closing the wheel guard. After closing
the guard the measuring cycle is started automaticaly.
1 . APPLICATION AND TECHNICAL DATA
TROLL 3100 / 3105 balancing machine is designed for dynamic balancing of car and van wheels
in a single measurement cycle.
TECHNICAL DATA :
- max. wheel diameter
1,15 m
- wheel diameter
10” - 24”
- wheel width
2" - 10"
- accuracy of unbalance indications
1 g
- accuracy of unbalance location signal
3 stages
- measurement time
3 s
- machine weight
ok. 145 kg
- overall diamensions with closed shield:
1140x900x1150 mm
with open shield :
1140x1050x1450 mm
- whell weight
do 60 kg
- drive motor rating
0,25 kW
- spindle spind ( during measurement )
230 r.p.m.
- power supply
220 V / 50 Hz
- air supply
0,6-1,0 MPa
The balancing machine TROLL 3100/3105 is equipped with a speach synthetiser, emitting
confirmations of each operation performed and suggesting procedures for whel balancing.
Indications quantity and position unbalance take reading on monitor measurement.
Programme „hiden weight” allows on the partition and the spacing of balancing slugs
on invisible spoken of alloy rim. Balancer is equiped an automatic stop at the top which
is blocking of wheel for both point of unbalancing. The brake release is seting after a
little displacement (ca. 3 grades) of wheel from shown unbalancing points or after press
the button on the keyboard which indicate a disapperation of arrows.
2 . INSTALLATION
TROLL - 3100 / 3105 balancing machine should be installed in a closed, dry room, heated during
auttumn / winter season. The machine should be installed on a hard and levelled floor. The balancing
machine should be installed on three rubber pads, suppiled with the machine (item 28, fig. 2)
which should be inserted under the three flat feet welded to the machine base.
