ITT Goulds Pumps IC, Инструкция по установке, эксплуатации и обслуживанию

Страница: 50 / 97

It is not necessary to remove the end plate from the pump side of the bearing housing. You can
access the bearing-housing tap bolts without removing this end plate if maintenance of internal
pump parts is necessary.
6. Remove the pump half of the coupling guard:
a) Slightly spread the bottom apart.
b) Lift upwards.
1
2
3
4
Item Description
1. Annular groove
2. Pump-side end plate
3. Driver
4. Pump half of the coupling guard
5.3 Check the rotation
WARNING:
• Starting the pump in reverse rotation can result in the contact of metal parts, heat
generation, and breach of containment. Ensure correct driver settings prior to starting
any pump.
• Failure to disconnect and lock out driver power may result in serious physical injury or
death. Always disconnect and lock out power to the driver before performing any in-
stallation or maintenance tasks.
• Electrical connections must be made by certified electricians in compliance with
all international, national, state, and local rules.
• Refer to driver/coupling/gear manufacturer's installation and operation manuals
(IOM) for specific instructions and recommendations.
1. Lock out power to the driver.
2. Make sure that the coupling hubs are fastened securely to the shafts.
3. Make sure that the coupling spacer is removed.
The pump ships with the coupling spacer removed.
4. Unlock power to the driver.
5. Make sure that everyone is clear, and then jog the driver long enough to determine that the di-
rection of rotation corresponds to the arrow on the bearing housing or close-coupled frame.
6. Lock out power to the driver.
5.4 Couple the pump and driver
5.3 Check the rotation
48 Model IC, ICI, ICH, ICIH Installation, Operation, and Maintenance Manual