6 - Operation
Operating Modes
Infinium LiHa and Infinium RoMa Operating Manual - Document # 1000000110155 v00
6 - 3
6.2 Operating Modes
Possible
Operating
Modes
The Infinium LiHa and Infinium RoMa can be run in two different operating modes:
Routine operation mode (operator)
–
This is the normal operating mode, in which the application is run.
–
In this mode, the Infinium LiHa and Infinium RoMa is controlled by the
runtime controller of the corresponding application software.
•
Refer to cross references above.
Setup and service mode (field service engineer)
–
Serves to set up the instrument, to make adjustments and to run tests.
–
In this mode, the Infinium LiHa and Infinium RoMa is controlled by the
setup and service software.
•
Refer to the “Instrument Software Manual”.
6.3 Operating in Routine Operation Mode
6.3.1 Safety Instructions
WARNING
Automatically moving parts.
Injuries (crushing, piercing) possible if the safety panels are not in place or if the
standard front safety panel is installed. The standard front safety panel is partially
open, allowing access to the worktable and continuous load
Before starting the Infinium LiHa and Infinium RoMa, make sure that the
safety panel is closed.
Never operate the instrument with the safety panels open.
Do not reach into the instrument through the aperture beneath the yellow line
on the instrument front side.
WARNING
Contamination risks through contamination of the worktable or frame. Hazardous
liquids or samples can be spilled onto the worktable, due to the failure of the liquid
system or a handling module, such as the RoMa.
Visually inspect all hardware components, e.g. the worktable, the RoMa, etc.,
for possible spillage of hazardous liquids.
Make sure that the containers are accurately positioned on the worktable.
Wear appropriate personal protective equipment, such as gloves, lab coats
and protective eye wear