3 - Technical Data
Technical Data
Infinium LiHa and Infinium RoMa Operating Manual - Document # 1000000110155 v00
3 - 5
Electrical
Safety
Classification with regard to electrical safety according to EN/IEC standards:
Power Switch
The power switch is placed at the level of the front access panel. The power
switch does not switch the mains voltage directly, but gives a control signal to the
power supply.
Note:
At installation or later movement of the instrument, ensure that it is always
possible to unplug the mains cable at the instrument.
3.2.3 Status Lamp
The status lamp is located above the diluters in the center of the instrument front
surface. It displays the instrument operational states with red and green light that
is either continuous or flashing. When the status lamp light is red, an acoustic
alarm sounds (status lamp functions: Refer to
).
The illuminated area is 540 x 18 mm (21.26 x 0.7 in.).
Tab. 3-4
Electrical specifications (safety)
Overvoltage category
II
IEC 60664-1
Pollution degree
2
(EN) IEC 61010-1
Tab. 3-5
Power switch specifications
Specification
Description
Circuit break
By unplugging the instrument.
Power on delay
0.2 - 0.5 sec.
Power off delay
a)
a) To prevent unintentional switching off, which could result in loss of process data
1 - 2 sec.