IBM TotalStorage NAS Gateway 500, Руководство по обслуживанию

Страница: 365 / 471

3. Align the processor-card connector with the docking connector located on the CEC backplane.
4. Carefully insert the processor assembly into the system.
5. As the processor connector is seated into its CEC backplane docking connector, begin lowering the
processor-assembly release handles. This action correctly seats and locks the processor assembly to
the CEC backplane.
6. If necessary, replace the processor filler panel.
7. Replace both removed media drives as described in “Media drive replacement” on page 338.
8. Replace the front bezel as described in “Front bezel replacement” on page 315.
9. Replace the service access cover as described in “Service access cover replacement” on page 314.
10. Reconnect both system power sources.
11. Push the system drawer back into the operating position as described in “Returning the NAS Gateway
500 to the operating position” on page 313.
12. Power on the system as described in “Starting the system” on page 311. If you want to run system
verification during this power up, see Chapter 7, “Verifying the hardware operation”, on page 243.
13. If the NAS Gateway 500 has successfully powered on, close the rack doors.
Chapter 11. Removal and replacement procedures
345