IBM TotalStorage NAS Gateway 500, Руководство по обслуживанию

Страница: 341 / 471

3. Pull the release latch off the latch bracket post.
1
2
3
4
5
6
6
7
7
8
8
1 System drawer-release latch 5 System drawer-release latch
2 System drawer-release latch bracket (right) 6 Retaining screws
3 NAS Gateway 500 7 Release latch retaining screw
4 System drawer-release latch bracket (left) 8 Latch bracket post
Drawer-release latch replacement
To replace one of the NAS Gateway 500 drawer-release latches, do the following:
1. If you have not already done so, open the front rack door and place the system into the service
position as described in “Placing the NAS Gateway 500 into the service position” on page 312.
2. Push the release latch onto the latch bracket post.
3. Secure the drawer-release latch onto the latch bracket post with a release latch retaining screw.
4. Push the system drawer back into the operating position as described in “Returning the NAS Gateway
500 to the operating position” on page 313.
Drawer-release latch bracket removal
To remove the NAS Gateway 500 drawer-release latch brackets, do the following:
1. Open the front rack door and place the system into the service position as described in “Placing the
NAS Gateway 500 into the service position” on page 312.
2. Remove the front bezel as described in “Front bezel removal” on page 315.
3. Remove the drawer-release latch as described in “Drawer-release latch removal” on page 320.
Chapter 11. Removal and replacement procedures
321