IBM TotalStorage NAS Gateway 500, Руководство по обслуживанию

Страница: 257 / 471

Table 17. Common firmware error codes (continued)
Error code Description Action or
possible failing FRU
B1FD 0015 Too many firmware update diskettes inserted (or
wrong or faulty update image)
1. Ensure the firmware update image is correct
for the specific system type and model.
2. Replace the update diskettes with a new set
of firmware update diskettes.
B1FD 0016 Diskette read error
1. The firmware diskette might be faulty. Try
another diskette.
2. Replace the diskette drive.
3. Replace the CEC backplane
Location code: U0.1-P1
B1FD 001A Service processor recovery mode update fault Reset service processor (by activating pinhole
reset switch or by disconnecting, and then
reconnecting power).
B1FD 001E Service processor recovery mode update fault Wrong firmware update diskette. (Insert correct
diskette.)
B1FD 001F Bad firmware update diskette Replace diskette.
Scan log dump progress codes
A scan dump is the collection of chip data that the service processor gathers after a system malfunction,
such as a checkstop or hang. The scan dump data might contain chip scan rings, chip trace arrays, and
SCOM contents. For more information on scan dumps, refer to “Scan Log Dump Policy” on page 262.
The following table shows the error code produced by a scan dump.
Table 18. Scan log dump progress codes
Error Code Description Action/Possible Failing FRU
A1FF 3000 Scan log dump request rejected This is an informational message. The service processor
firmware was not able to perform a scan log dump even
though one was requested.
D130 xxxx Scan log dump in progress Informational message only. As the dump progresses,
the xxx characters in the display changes. When
completed, the system might reboot, depending on the
reboot policy settings.
Chapter 5. Error code to FRU index
237