IBM Netfinity 3500, Руководство пользователя

Страница: 148 / 294

POST Messages
POST Message Description
110
111 A memory parity failure occurred during testing of the system
board.
Action: Run the diagnostic programs to verify that a problem
exists in a DIMM. (See “Running the Diagnostic Test Programs”
on page 124 for information on running the diagnostic programs
that come with your server.)
See “Working with Memory Modules” on page 63 if you need to
reconfigure the system memory to aid in identifying the defective
DIMM.
If you cannot identify the defective DIMM in this way, have the
system serviced.
114 An adapter read-only memory (ROM) error occurred.
Action: Remove all adapters that are not required for system
startup and reinstall them one at a time, powering on after each
is reinstalled. When this message displays, replace the adapter
that you just installed.
If you cannot isolate and correct the problem, have the system
serviced.
121 A hardware error occurred.
Action: Have the system serviced.
151 A real-time clock (RTC) error occurred.
Action: Have the system serviced.
161 The battery on the system board is dead.
CAUTION:
The lithium battery presents a fire, explosion, or severe burn
risk. Do not recharge it, disassemble it, heat it, incinerate it, or
expose its cell contents to water. Dispose of the battery as
required by local ordinances or regulations.
Replace the battery with the same or equivalent type
recommended by the manufacturer. Danger of explosion if
lithium battery is incorrectly replaced.
Action: Replace the battery. For additional information on
battery use, disposal, and replacement, see “Lithium Battery
Notice” on page ix and “Replacing the Battery” on page 179.
You can use the server until you replace the battery. However,
you must run the Configuration/Setup Utility program and set
the time and date each time that you turn on the server, until
you install a new battery. (For instructions on using the
Configuration/Setup Utility program, see “Using the
Configuration/Setup Utility Program” on page 28.)
130
Netfinity 3500 User's Handbook