IBM Netfinity 3500, Руководство пользователя

Страница: 66 / 294

Using the SCSISelect Utility
The default startup (boot) SCSI ID is 0 for an internal SCSI hard
disk drive in Channel A.
Ÿ
SCSI Device Configuration
Select this choice to configure SCSI device parameters. Before
you can make updates, you must know the ID of the device
whose parameters you want to configure.
Note: When the Maximum Sync Transfer Rate is set to 40.0,
this value represents the transfer rate for UltraSCSI
devices. When this value is set to 20.0, it represents the
transfer rate for Fast SCSI devices.
Ÿ
Advanced Configuration Options
Select this choice to view or change the settings for advanced
configuration options. These options include enabling support
for large hard disk drives and support for drives with UltraSCSI
speed.
To reset the SCSI controller defaults, press F6; then, follow the
instructions on the screen.
SCSI Disk Utilities
To see the IDs that are assigned to each SCSI device or to format a
SCSI device, select SCSI Disk Utilities from the SCSISelect Utility
program menu.
To use the utility program, select a drive from the list. Read the
screens carefully before you make a selection.
Note: If you see the following message, you might have pressed
Ctrl
+
A before the selected drives were ready. Restart the
server, and watch the SCSISelect messages as each drive spins
up. After the drive that you want to view or format spins
up, press Ctrl
+
A .
48
Netfinity 3500 User's Handbook