IBM Netfinity 3500, Руководство пользователя, Страница: 52 / 294

Using the Configuration/Setup Utility Program
If a power failure occurs, when power is restored, the
server will automatically restart and resume operating in
this mode, without operator intervention.
Dual If you press the power switch to start the server, the server
operates in password prompt On mode.
If you start the server by an unattended method, such as
remotely over a LAN, the server operates in password
prompt Off mode.
To set or change a power-on password:
1. Select Power-On Password.
2. Enter your password and press the Down Arrow (
↓
) key.
You can use any combination of up to seven characters (A–Z,
a–z, and 0–9) for this password. Keep a record of the password
in a safe place.
3. Enter your password again.
4. At Password Prompt, select Off, On, or Dual. Press the Left
Arrow (
←
) or Right Arrow (
→
) key to toggle between selections.
Note: If Update POST/BIOS from network is enabled, you
cannot select On. In this case, select Dual. If the
password prompt mode is set to On when Update
POST/BIOS from network
is enabled, the mode will
automatically be reset to Dual.
5. Select Change Power-On Password, and follow the instructions
on the screen.
Notes:
1. If a power-on password is set and then forgotten, you must
remove the server cover and move a jumper on the system
board. (Refer to “Using the Clear CMOS Request Jumper to
Erase Forgotten Passwords” on page 204 for further
information.)
2. If a power-on password is set and the password prompt is set to
Off, the pointing device (mouse) is disabled until you enter the
power-on password.
34
Netfinity 3500 User's Handbook