IBM Netfinity 3500, Руководство пользователя

Страница: 91 / 294

The following are some important points to remember when
connecting power and signal cables to internal drives:
Ÿ
The diskette drive, hard disk drive, and CD-ROM drive that are
preinstalled in your server come with power and signal cables
attached. If you replace any drives, it is important to remember
which cable is attached to which drive.
Ÿ
When you install a drive, ensure that the connector at the end of
the signal cable is connected to the system board.
Ÿ
If two IDE devices are used on a single cable, one must be
designated as the primary or master device and the other a
secondary or subordinate device; otherwise, some of the IDE
devices might not be recognized by the system. The primary or
secondary designation is determined by switch or jumper
settings on each IDE device.
In this server, the CD-ROM drive is the primary device. If you
install a second IDE device, it must be the secondary device.
Ÿ
To attach an external SCSI drive, you must install an
appropriate adapter in the server.
For help in selecting drives, cables, and other options for your
server, do one of the following:
Ÿ
Within the United States, call 1-800-IBM-2YOU (1-800-426-2968),
your IBM reseller, or your IBM marketing representative.
Ÿ
Within Canada, call 1-800-565-3344 or 1-800-465-7999.
Ÿ
Outside the United States and Canada, contact your IBM reseller
or IBM marketing representative.
Chapter 4. Installing Options
73