IAI MSEL, Инструкция по эксплуатации, Страница: 175 / 234

Chapter 6
Troubleshooting
167
In the panel window, the error numbers follow E in the display.
Error No. Error name Description, action, etc.
A04 System mode error at core update [Detail & Cause]
An update command was received when the system was
not in the core update mode.
[Countermeasure]
Establish the setting in the update mode for core part. (For
maintenance)
A05 Motorola S record format error The update program file is invalid. Check the file.
A06 Motorola S checksum error The update program file is invalid. Check the file.
A07 Motorola S load address error The update program file is invalid. Check the file.
A08 Motorola S write address over
error
The update program file is invalid. Check the file.
A09 Flash-ROM timing limit over error
(Write)
Error writing the flash ROM
A0A Flash-ROM timing limit over error
(Erase)
Error erasing the flash ROM
A0B Flash-ROM verify error Error erasing/writing the flash ROM
A0C Flash-ROM ACK timeout Error erasing/writing the flash ROM
A0D Head sector number specification
error
Error erasing the flash ROM
A0E Sector count specification error Error erasing the flash ROM
A0F Write-destination offset address
error (Odd-numbered address)
Error writing the flash ROM
A10 Write-source data buffer address
error (Odd-numbered address)
Error writing the flash ROM
A11 Invalid core-code sector block ID
error
The core program already written to the flash ROM is
invalid.
A12 Core-code sector block ID erase
count over
The number of times the flash ROM can be erased was
exceeded.
A13 Flash-ROM write request error
when erase is incomplete
When updating, a flash-ROM write command was
received before a flash-ROM erase command. Check the
update program file and perform update again.
A14 Busy-status reset timeout error at
EEPROM write
A busy-status reset timeout occurred after executing
EEPROM write.
A15 EEPROM write request error due
to no-EEPROM in target
An EEPROM write request was received for a driver or
other unit with CPU not equipped with EEPROM.
A16 EEPROM read request error due
to no-EEPROM in target
An EEPROM read request was received for a driver or
other unit with CPU not equipped with EEPROM.
A17 Message checksum error (IAI
protocol reception)
The checksum in the received message is invalid.
A18 Message header error (IAI
protocol reception)
The header in the received message is invalid. Invalid
header position (message is 9 bytes or less) is suspected,
among other reasons.
A19 Message station number error (IAI
protocol reception)
The station number in the received message is invalid.
A1A Message ID error (IAI protocol
reception)
The ID in the received message is invalid.
A1C Message conversion error The transmitted message does not match the message
format or contains invalid data. Check the transmitted
message.
Message level errors
A1D Start mode error A start not permitted in the current mode (MANU/AUTO)
was attempted.