HUSABERG FE 450 AUS, Руководство по ремонту

Страница: 77 / 285

11/WIRING HARNESS, BATTERY
75
–
Check that the power consumer is functioning properly.
–
Close the fuse box cover.
–
Mount the seat. ( p. 59)
14.5
Removing the battery
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep the battery away from sparks or open fire. Charge only in well-ventilated rooms.
–
In the event of skin contact, rinse with large amounts of water. If battery acid gets in the eyes, rinse with water for at least
15 minutes and contact a physician.
–
Switch off all power consumers and switch off the engine.
–
Remove the seat. ( p. 59)
100422-10
–
Detach fuse box

and swing it to one side.
–
Detach connector

and swing it to one side with connector

.
–
Remove screws

and swing battery cover

with the starter relay to one side.
Swing the EFI control unit to one side.
100423-10
–
Disconnect the negative and positive cables of the battery.
Info
Pay attention to the contact disks between the cable sockets and battery
terminals.
–
Lift battery

up and out.
14.6
Installing the battery
100423-11
–
Insert battery

into the battery tray with the terminals facing to the rear.
Battery (YTZ7S) ( p. 224)
100424-10
–
Connect the positive and negative cables.
Info
Contact disks

must be mounted between battery terminals

and cable
sockets

with the claws facing up.
–
Tighten the screws.
Guideline
Screw, battery terminal M5 3 Nm (2.2 lbf ft)