HUSABERG FE 450 AUS, Руководство по ремонту

Страница: 36 / 285

04/SHOCK ABSORBER, SWINGARM
34
7.8
Adjusting the riding sag
–
Remove the shock absorber. ( p. 34)
–
After removing the shock absorber, clean it thoroughly.
–
Choose and mount a suitable spring.
Guideline
Spring rate
Weight of rider: 65… 75 kg (143… 165 lb.) 69 N/mm (394 lb/in)
Weight of rider: 75… 85 kg (165… 187 lb.) 72 N/mm (411 lb/in)
Weight of rider: 85… 95 kg (187… 209 lb.) 76 N/mm (434 lb/in)
Info
The spring rate is shown on the outside of the spring.
Smaller weight differences can be compensated by changing the spring preload.
–
Install the shock absorber. ( p. 34)
–
Check the static sag of the shock absorber. ( p. 32)
–
Check the riding sag of the shock absorber. ( p. 33)
–
Adjust the rebound damping of the shock absorber. ( p. 32)
7.9
Removing the shock absorber
–
Jack up the motorcycle. ( p. 9)
100374-10
–
Remove screw

and lower the rear wheel with the swing arm as far as possible
without blocking the rear wheel. Fix the rear wheel in this position.
–
Remove screw

, push splash protector

to the side, and remove the shock
absorber.
7.10
Installing the shock absorber
100374-11
–
Push splash protector

to the side and position the shock absorber. Mount and
tighten screw

.
Guideline
Screw, top shock absorber M12 80 Nm
(59 lbf ft) Loctite ® 243™
–
Mount and tighten screw

.
Guideline
Screw, bottom shock
absorber M12 80 Nm
(59 lbf ft) Loctite ® 243™
Info
The heim joint for the shock absorber at the swing arm is Teflon coated. It
must not be greased with grease or with other lubricants. Lubricants dis-
solve the Teflon coating, thereby drastically reducing the service life.
–
Remove the motorcycle from the work stand. ( p. 9)