HUSABERG FE 450 AUS, Руководство по ремонту

Страница: 13 / 285

01/FORK, TRIPLE CLAMP
11
Info
Turn clockwise to increase spring preload, turn counterclockwise to reduce
spring preload.
Adjusting the spring preload has no influence on the absorption setting of
the rebound damping.
Basically, however, you should set the rebound damping higher with a
higher spring preload.
5.4
Bleeding the fork legs
–
Jack up the motorcycle. ( p. 9)
100379-10
–
Remove bleeder screws

briefly.
Any excess pressure escapes from the interior of the fork.
–
Mount and tighten bleeder screws.
–
Remove the motorcycle from the work stand. ( p. 9)
5.5
Cleaning the dust boots of the fork legs
–
Jack up the motorcycle. ( p. 9)
–
Loosen the fork protection. ( p. 11)
100380-10
–
Push dust boots

of both fork legs downwards.
Info
The dust boots should remove dust and coarse dirt particles from the fork
tubes. Over time, dirt can penetrate behind the dust boots. If this dirt is not
removed, the oil seals behind can start to leak.
Warning
Danger of accidents
Reduced braking efficiency due to oil or grease on the
brake discs.
–
Always keep the brake discs free of oil and grease, and clean them with
brake cleaner when necessary.
–
Clean and oil the dust boots and inner fork tube of both fork legs.
Universal oil spray ( p. 266)
–
Press the dust boots back into their normal position.
–
Remove excess oil.
–
Position the fork protection. ( p. 12)
–
Remove the motorcycle from the work stand. ( p. 9)
5.6
Loosening the fork protection
100381-10
–
Remove screws

and take off clamp.
–
Remove screws

on the left fork leg. Push the fork protection downwards.
–
Remove the screws on the right fork leg. Push the fork protection downwards.