HUSABERG FE 450 AUS, Руководство по ремонту

Страница: 155 / 285

32/CLUTCH
153
100449-10
–
Inject the liquid into the system until it escapes from drill hole

of the clutch
slave cylinder without bubbles.
–
To prevent overflow, drain fluid occasionally from the clutch slave cylinder reser-
voir.
–
Remove the bleeding syringe. Mount and tighten screws bleeder screw.
–
Clean the sealing surfaces of the clutch slave cylinder and engine housing.
–
Position the seal and O-ring on the clutch slave cylinder and install it.
–
Mount and tighten the screws.
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level under top level of container. 4 mm (0.16 in)
–
Position the cover with the membrane. Mount and tighten the screws.
–
Check that the clutch is functioning properly.