HUSABERG FE 450 AUS, Руководство по ремонту

Страница: 144 / 285

30/ENGINE ASSEMBLY
142
300326-11
–
Slide the outer clutch hub onto the gearbox main shaft. Turn the oil pump gear
until the gear of the outer clutch hub meshes.
–
Slide on washer

and inner clutch hub

.
300325-11
–
Position the new lock washer and mount nut

. Tighten the nut, holding the inner
clutch hub with a special tool.
Guideline
Nut, inner clutch hub M18x1.5 80 Nm (59 lbf ft)
Clutch holder (51129003000) ( p. 268)
–
Secure the nut with the lock washer.
20.19
Installing the primary gear nut
300362-10
–
Block the clutch hub and primary gear using the special tool.
Gear segment (80029004000) ( p. 273)
–
Mount and tighten the nut.
Guideline
Nut, primary gear M20LHx1.5 120 Nm
(88.5 lbf ft) Loctite ® 243™
20.20
Installing the clutch discs
400535-10
–
Thoroughly grease the clutch facing discs.
Engine oil (SAE 10W/50) ( p. 263)
–
Insert support ring

into the outer clutch hub.
–
Insert pretension ring

with the open side facing outward.
–
Position the machined clutch facing disc

with the recess for the pretension ring
into the outer clutch hub.
–
Beginning with an intermediate disc, alternately insert all other clutch facing discs
and intermediate discs into the outer clutch hub.
300321-11
–
Insert the pressure piece.
–
Position the pressure cap. Mount screws

with the washers and springs. Tighten
the screws in a crisscross pattern.
Guideline
Screw, clutch spring M6 10 Nm (7.4 lbf ft)