![HUSABERG FE 450 AUS Скачать руководство пользователя страница 61](http://html1.mh-extra.com/html/husaberg/fe-450-aus/fe-450-aus_repair-manual_2187561061.webp)
07/FUEL TANK, SEAT, TRIM
59
10.1
Removing the seat
100362-10
–
Pull on the loop
while raising the rear of the seat.
–
Pull the seat back and lift it off.
10.2
Mounting the seat
400514-10
–
Attach the seat to the hooks on fuel tank
and on the top part of subframe
,
and lower it at the rear while pushing forward.
–
Guide lock bolt
into the lock housing and push down the rear of the seat until
the lock bolt engages audibly.
–
Finally, check that the seat is correctly mounted.
10.3
Removing the fuel tank
Danger
Fire hazard
Fuel is highly flammable.
–
Never fill up the vehicle near open flames or burning cigarettes, and always switch off the engine first. Be careful that no
fuel is spilt, especially on hot vehicle components. Clean up spilt fuel immediately.
–
Fuel in the fuel tank expands when warm and can escape if the tank is overfilled. See specifications on filling up with fuel.
Warning
Danger of poisoning
Fuel is poisonous and a health hazard.
–
Avoid contact between fuel and skin, eyes and clothing. Do not inhale fuel vapors. If fuel gets into your eyes, rinse immedi-
ately with water and contact a doctor. Wash affected skin areas immediately with soap and water. If fuel is swallowed, con-
tact a doctor immediately. Change clothing that has come into contact with fuel. Store fuel in a suitable canister according
to regulations and keep it out of the reach of children.
–
Remove the spoiler. (
–
Remove the air filter. (
100432-10
–
Remove screws
.
–
Pull the top of the subframe outward slightly at the front and remove it.
100433-10
–
Remove screw
.
Содержание FE 450 AUS
