Honeywell Gamewell-FCI E3 Series, Руководство по установке и эксплуатации

Страница: 111 / 190

110 E3 Series Installation/Operation Manual
—
P/N 9000-0574:I 11/04/10
E3 Series System Connections Intelligent Loop Interface XP95-Slave Board Connections
INPUT/CONTROL
MODULE
NCM-1
ILI95-S-E3
B (-)
A (-) A (+)
B (+)
DOTTED LINES INDICATE CLASS A,
STYLE 6 WIRING.
SMOKE/HEAT
SENSOR
3.5 Intelligent Loop Interface XP95-Slave Board Connections
3.5.1 Signaling Line Circuits
Figure 3.5.1.1 Signaling Line Circuits
The ILI95-S-E3 provides two (2),24 VDC Class A,
Style 6, 7 or Class B, Style 4 signaling line circuits.
See Figure 3.5.1.1 for wiring information. Style 7
wiring requires the use of an M500X Isolator Module,
(ILI-S-E3), or XP95-LI Line Isolator or
XP95-LIB Line Isolator Base (ILI95-S-E3) on both
sides of a device.
Wiring Instructions
SLC 1 Style 4 TB7-3 (-), TB7-4 ( + )
SLC 1 Style 6 TB4-3 (-), TB4-4 (+)
SLC 2 Style 4 TB7-1 return, TB7-2 return
TB7-3 out, TB7-4 out
SLC-2 Style 6 TB4-1 return, TB4-2 return
TB4-3 out, TB4-4 out
(Polarity markings indicate the polarity that should be
maintained throughout the circuit. Polarity connected
to the circuit must be observed on all devices).
Circuit Ratings
24 VDC (nominal)
FWR
Current:
0.051 amp Max (supervisory)
0.136 amp max. (alarm)
0.100 amp max. Steady State
(short circuit)
40 Ohms max. line impedance
0.5
µf max. line capacitance
Ground fault test
impedance:
Zero ohms
Wiring: 18 AWG minimum,
twisted-pair, unshielded
Power-limited Supervised