Hitachi RWM-(H)FSN3E, Руководство по обслуживанию

Страница: 351 / 424

12 Troubleshooting
SMGB0070 rev. 1 - 08/2011
341
12
Alarm code
05
Code abnormal operation of picking up phase signal
• The RUN LED flickers and “ALARM” is displayed on the remote control switch.
•
The unit number, the alarm code and the unit code are alternately displayed on the set temperature section. The unit
number and the alarm code are displayed on the display of the outdoor unit PCB.
- This alarm is displayed when the main power source phase is reversely connected or one phase is not connected.
Correctly connect each
phase of the power source
Yes
Reverse phase connection
(Only 3 phases unit)
No
Yes
No
Correctly connect each
phase of the power source
Faulty PCB1 or other cause
(see below)
PCB1 is normal
PCB1 is normal
Single phase
and 3 phases
(Is there any phase which is
not connected)?
RAS-(2-6)(HVRN2/HVRNME-AF) RAS-(4-10)HRNME-AF
Voltage for unit
to be suspended
Running voltage:
207 to 253V
Setting voltage:
Less than 187V
Voltage for unit
to be suspended
Running voltage:
342 to 456V
Setting voltage:
Less than 323V
Phenomenon Cause Check item
Action
(Turn OFF the main switch)
Activation of
reverse phase
sensor in the
outdoor unit
Reverse or single phase
Check it according to
the electrical wiring
Replacing wires, repair, tighte-
ning screws or correct wiring
Faulty outdoor unit PCB - Replace PCB if faulty